TERA® - DSX-5000 CableAnalyzer
To test to 1 GHz, please use the DSX-5000 CableAnalyzer which has been approved by Siemon.
TERA® is Siemon's Category 7 connector used in Class F and FA cabling systems. It’s a non RJ-45, shielded connector. Since it is not RJ45 based, you cannot use your DSX-PLA004 Permanent Link Adapters. Likewise, you cannot use your DSX-CHA004 Channel Adapters.
To test Siemon TERA® correctly, you need to order the DSX-TERA-KIT for your DSX-5000 CableAnalyzer. If you have a DSX-8000 CableAnalyzer, we will have available a 2GHz version of this kit in the near future.
Do NOT order just the DSX-PLA011s TERA Permanent Link Adapters. You also need at least one DSX-CHA011 TERA® Channel Adapter so you can Set Reference with the main and remote units. (Shown below) Ordering the DSX-TERA-KIT is the best option when you initially need to start testing on a TERA® project.
테스트 한계
You will find the Class F and FA test limits under the ISO folder:
When setting up your test, from the TEST SETUP screen, choose the correct Cable Type (we are using Generic Cat 7A S/FTP in this example), then select your Test Limit. Tap the Test Limit: TIA
Cat 6A Perm. Link default setting (1), This will open the Last Used page, Tap MORE (2), Tap ISO (3) and then select the Class F or Class Fa Test Limit required (4). Remember to SAVE (5).
Class FA is rated to 1,000 MHz (1 GHz). You need a Level V tester such as the DSX-5000 CableAnalyzer to test this class of installation.
Class F is rated to 600MHZ. You need a Level IV or better tester to test this class of installation.
If you purchase the kit (recommended), part number DSX-TERA-KIT, it will come with (2) DSX-PLA011 and (2) DSX-CHA011 adapters.
